From: sleeper75se (sleeper75se_at_yahoo.se)
Date: 2002-02-01 16:55:33
--- In buildcheapeeg_at_yahoogroups.com, "S Goonesekera" <syg1971_at_yahoo.com> wrote:
Hi SYG,
> Hi All
>
> If you are ready to build the device I know one place making PCBs
> for very low price. I make 5 pcs for $50(10cm x10 cm).
>
that sounds good. I have a bunch of questions: :o)
How much for 14x13 cm, double sided, through-hole plated, panel?
Can they handle 10 mil (0.25 mm) wide traces and 0.6mm holes?
Does the board come with a solder mask?
How much would shipping to Europe/US cost?
What board material are they using? Fiberglass?
> Their quality is not very high but acceptable.
What kind of quality problems do they have?
>
> If any one can send me the pcb file. I get it done.
>
What kind of file format do they use? Is gerber plots generated by
Protel ok?
> But I don't have the programmer for the AT90XXX chip I have only
> for PIC16F877. which I use for my EEG.
You don't need much of a programmer. Just connect the right pins on
the microcontroller directly to the PC's parallel port. The
programming specs are in the datasheets, so it is easy to write your
own software.
Regards,
Andreas
This archive was generated by hypermail 2.1.4 : 2002-07-27 12:28:37 BST